![Ohm-Labs, Inc.](../_img/banner.png)
KV-Series Legacy High Voltage Dividers
(Replaced by KV-A series)
- RATIO ACCURACY <0.01 %
- LOW TEMPERATURE & POWER COEFFICIENTS
- THREE RATIO OUTPUTS
Originally designed by Julie Research Laboratories, the KV-series DC high voltage dividers are available by special order. The recommended replacement is the KV-A model.
The KV dividers use precision, wire wound resistors which are selected and matched to reduce the effects of changes in temperature and applied voltage. They may be operated safely up to full rated voltage without damage.
Three standard output taps offer convenient ratios for accurate measurement of voltages in overlapping ranges. The standard output taps provide 1, 10 and 100 volts output at full input. The 100 V output can be exchanged for a 1000 V output if requested.
Standard models available are: 10 kV, 15 kV and 25 kV. The KV series provides a nominal input and output impedance 1000 ohms/volt.
Leakage and corona effects have been reduced by careful internal engineering design and layout. All dividers are supplied with ISO 17025 accredited, traceable reports of calibration up to full rated voltage.
The KV dividers may be used with mains frequency ac (50-60 Hz) with reduced accuracy.
Special ratios or case styles can be supplied upon request.
All models include ISO17025 accredited calibration through full voltage range.
Model Selection Guide
Model | Input | Standard Outputs |
KV 10 | 10,000 V | 1) 1 V |
KV 15 | 15,000 V | |
KV 25 | 25,000 V | |
Size: | 10" w x 6" d x 5" h 9" h including input post and ball 25.4 cm w x 15.2 cm d x 12.7 cm h 23 cm h including post and ball |
|
Weight: | Approximately 15 lbs / 7 kg |
Related Products
Additional Resources
Resistance Standards | Precision Shunts | Instruments | High Voltage Dividers | Resistors | Calibration
Copyright ©
Ohm-Labs, Inc. | Site Map | Privacy Policy & Terms of Use | Nupic Approved Calibration Vendor
Site by: Ed Doherty Jr. | Menu by: Apycom